The information, calculations, pump placement recommendations, pressure estimates, elevation profiles, and hydraulic results generated by this application are provided for planning, visualization, and informational purposes only.

Results are based on user-provided inputs, publicly available mapping/elevation data, estimated hydraulic models, and generalized assumptions. Actual field conditions may differ significantly due to, but not limited to:

• Pipe condition, wear, and age
• Hose type and manufacturer specifications
• Elevation accuracy limitations
• Terrain changes and routing variations
• Fittings, manifolds, valves, and restrictions
• Fluid properties and temperature
• Pump performance and equipment condition
• Installation methods and operational practices

Compass Technologies does not guarantee the accuracy, completeness, suitability, or fitness of any calculation, recommendation, pressure estimate, booster spacing, or route generated by this software.

Users are solely responsible for:

• Verifying all calculations
• Confirming equipment ratings and limitations
• Ensuring safe operating pressures
• Following manufacturer specifications
• Performing field validation and engineering review
• Maintaining compliance with all applicable regulations, permits, and safety requirements

This software shall not be used as the sole basis for engineering design, operational decisions, safety-critical activities, or field deployment without independent verification.

Compass Technologies assumes no liability for equipment damage, product failure, environmental incidents, downtime, financial loss, personal injury, or other damages arising from use of this application.

By using this software, the user acknowledges and accepts these limitations.

Compass Technologies — A Step in the Right Direction